Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Service procedure: Bearing

Ford — Service procedure: Bearing

A Ford service procedure — check it applies to your exact model before use.

Browse Ford generators & specs →

Before you start

  • Unless otherwise instructed, at no time when the timing chain are removed and the cylin
  • The bolts are a part of the valve cover (6582) and are not to be removed. LH is shown
  • RH is similar. • Fully loosen the sixteen bolts, and remove the valve cover gasket (6584).

Procedure

  1. Remove the four bolts.
  2. Remove the water pump pulley.

Tools required

  • level indicator tube (6754).
  • use the Rear Crankshaft Slinger Replacer and the

Source: manual:WSG1068 Sec. 02-B Engine.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.