Ford 80 Series / 84A2-F140 — Pump Reassembly
Repair & overhaul · Pump casing
For the Ford 80 Series / 84A2-F140, from the Ford owner's manual.
Browse Ford generators & specs →
Procedure
- If the wear plate (26) was removed, secure the replacement wear plate to the pump casing with the hardware (27 and 28).
- Remove the two capscrews temporarily securing the seal plate.
- Install the same thickness of pump casing gaskets (25) as previously removed.
- Secure the pump casing to the intermediate with the nuts (24).
- Adjust the clearance between the impeller and wear plate to .008 to .015 inch by adding or removing casing gaskets.
- Reinstall the rubber mounting isolators and any leveling shims; secure the casing to the base with the hardware (43, 44, 45 and 46).
Tools required
- Feeler gauge Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- .008 to .015 inch between the impeller and the wear plate
- After the impeller binds, add .012 inch of gaskets
Source: Ford owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.