Fischer Panda 12mini / Panda 12 mini PMS Digital — Exchange impeller
Maintenance · raw water pump
For the Fischer Panda 12mini / Panda 12 mini PMS Digital, from the Fischer Panda service manual.
Applies to: Fischer Panda MINI, Fischer Panda Panda 12 mini PMS Digital, Kubota D722 engine
Procedure
- Close raw water stop cock.
- Remove cover of raw water pump by loosening screws.
- Pull impeller from shaft with multigrip pliers.
- Mark impeller position before removal.
- Check impeller for damage and replace if necessary.
- Lubricate impeller with glycerin or non-mineral oil based lubricant.
- Install impeller on pump shaft in marked position.
- Fasten cover with new seal.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Replace every few months; if raw water does not appear within 5 seconds after start.
Full service-parts list: Fischer Panda MINI →, Fischer Panda Panda 12 mini PMS Digital →, Kubota D722 engine →
Source: Fischer Panda service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.