MP-5667 — Figure 6-25. Contact Pole Installation
For the MP-5667.
Before you start
- NOTE
Procedure
- 5. Repeat step 3 or 4 to install new poles for
- remainder of the contact set.
- 6. Energize coil and check operation of contacts.
- 7. Install
- contactor
- cover,
- tightening
- captive
- quarter-turn fasteners to secure cover in place.
- 6-10
- Reassembly/Disassembly
- MP-5667
- 9/96
- Notes
- Service Parts
- 7-1
- MP-5667
- 9/96
- Section 7. Service Parts
- Introduction
- Use this section to locate and identify service parts for
- the 25-400 ampere models of the automatic transfer
- switches that use electrically held or mechanically held
- contactors as the power conversion unit.
- The part
Tools required
- the same type of standard copper wire (gauge, color,
- Handle, latch
Specs & torque values
- column
- columns
- s
Source: manual:mp5667.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.