Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Air Filter Cleaning

Eilers.Com.Ar R200X — Air Filter Cleaning

For the Eilers.Com.Ar R200X.

Browse Eilers.Com.Ar generators & specs →

Before you start

  • Do not clean the filter element with gasoline or other solvent cleaners.
  • Do not use high pressure air, high pressure water or hot air to clean and/or dry the air filter. These can damage the performance of the air filter.

Procedure

  1. Remove the air filter from engine.
  2. Put the air filter on a flat surface and shake dust out.
  3. Liberally spray K&N Air Filter Cleaner onto both sides of the filter and allow to soak for 10 minutes to loosen the dirt.
  4. Wash out the dust with low pressure running water from the inside toward the outside.
  5. Dry the wet air filter in the shade for 2~3 hours. You can reduce drying time by blowing with a hair dryer on COLD or by blowing with low pressure compressed air.
  6. Apply air cleaner oil over the outside of the filter. If too much oil is applied, it will reduce performance.
  7. Reassemble air filter to engine.

Tools required

  • K&N Air Filter Cleaner

Source: manual:INSTALLATIONOPERATION-SERIES-R200.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.