Doosan C185 / C185WKUB-T2 — Field Replacement of Canopy Decals
Maintenance
For the Doosan C185 / C185WKUB-T2, from the Doosan owner's manual.
Applies to: Kubota 2403T engine
Procedure
- Wipe decal area with 70% isopropyl alcohol and a lint free cloth in a well ventilated area.
- Allow sufficient time for drying.
- Align decals prior to removing the backing.
- Peel one section of backing and squeegee decal from center to edges to remove air.
- Remove the remaining backing and repeat squeegee process.
- Repeat squeegee over entire decal surface; allow 24 hours for permanent bond.
- Remove air bubbles by pricking bubble center with a pin and squeegee air toward the hole.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Allow 24 hours for permanent bond
Source: Doosan owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.