Doosan C185 / C185WKUB-T2 — Before Towing
Operation
For the Doosan C185 / C185WKUB-T2, from the Doosan owner's manual.
Applies to: Kubota 2403T engine
Before you start
- Failure to follow these instructions CAN cause severe injury or death.
- Always raise (or remove) jack for maximum ground clearance before towing.
Procedure
- Assure tow vehicle has towing capacity for weight of this unit as stated on general data decal.
- Position the tow vehicle to align its hitch with the pintle eye or coupler of the compressor.
- Engage the parking brake and chock the tires of the tow vehicle.
- Stand to the side and ensure pin is FULLY inserted (secure) in tube of jack.
- Crank jack to seat pintle eye or coupler onto hitch; latch and lock hitch; cross safety chain(s) under drawbar; attach to vehicle.
- Crank jack to raise pad off the ground; pull pin from tube of jack.
- Fold jack handle down and forward; swing up jack tube and FULLY insert pin in tube.
- Remove tire chocks.
- Test brakes, if so equipped.
- Test lights (running, stop, and turn signals).
Source: Doosan owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.