Deutz — Removal and Refitment of Air Compressor

A Deutz service procedure — check it applies to your exact model before use.

Browse Deutz generators & specs →

Procedure

1. Remove outer V-belt half-pulley together with shims.
2. Remove V-belt.
3. Remove shims and inner V-belt half-pulley.
4. Take down lube oil pipe.
5. Remove air compressor.
6. Insert new O-seal, using grease.
7. Fit air compressor in place, as indicated by arrow.
8. Tighten bolts.
9. Fit lube oil pipe together with new Cu sealing rings.
10. Position inner V-belt half-pulley.
11. Position removed shims.
12. Fit V-belt and outer V-belt pulley.
13. Position remaining shims, if provided. Finger start the bolts.
14. Tighten bolts while turning engine over.
15. Check belt tension. In case of failure to attain the specified scale reading, repeat procedure.

Source: manual:KHD DEUTZ Workshop Manual B_FL _T 1988.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.