Detroit Diesel — Stationary Regeneration
Operation · Aftertreatment Device (ATD)
From a Detroit Diesel service manual — check it applies to your exact model before use.
Before you start
- During stationary regeneration the exhaust gases will be extremely HOT and could cause a fire if directed at combustible materials.
Procedure
- Obtain regeneration button (J-47384) and plug into the vehicle 9 pin diagnostic port, located on the driver side lower rear door opening.
- Depress and hold the button for four seconds.
- Engine speed will increase to 1600 rpm and exhaust temperatures will rise to acceptable dosing levels.
- After achieving the required exhaust temperatures, dosing will occur.
- The driver MUST stay with the vehicle throughout the regeneration process.
- At conclusion of regeneration, the engine speed will return to idle.
- Remove the regeneration button from the 9-pin diagnostic port.
Tools required
- Regeneration button (J-47384) Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Procedure will take 20 to 40 minutes
- Engine speed increases to 1600 rpm
Source: Detroit Diesel service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.