Detroit Diesel — Replace Spin-On Filter
Maintenance · Lubricating oil filter
From a Detroit Diesel service manual — check it applies to your exact model before use.
Before you start
- Mechanical tightening will distort or crack the filter adaptor.
- Do not clean multi-pack lube oil filter adaptors by hot tanking; clean by immersing in pure mineral spirits or clean fuel oil.
Procedure
- Remove the spin-on oil filter using strap wrench tool J 29917 with a 1/2 in drive socket wrench and extension.
- Discard the used oil filter. Clean the filter adaptor with a clean, lint-free cloth.
- Lightly coat the oil filter gasket (seal) with clean engine oil.
- Start the new filter on the adaptor and tighten by hand until the gasket touches the mounting adaptor head. Tighten an additional two-thirds turn.
- Start and run the engine for a short period and check for oil leaks. After approximately 20 minutes, add sufficient oil to raise the level to the proper mark on the dipstick.
Tools required
- Strap wrench J 29917 Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Detroit Diesel service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.