Detroit Diesel — Installation of FEPTO Kit
Installation · MBE 4000 Front Engine PTO (FEPTO)
From a Detroit Diesel service manual — check it applies to your exact model before use.
Before you start
- FALLING COMPONENT: To avoid injury from a falling component, ensure a proper lifting device is used.
- PERSONAL INJURY: To avoid injury from the projection of tools or other objects that may fall on or behind the vibration damper of an engine, always check and remove these items before starting the engine.
Procedure
- Install a flywheel guide pin (J-46172) into front end of crankshaft to aid in assembly.
- Install the oil deflector.
- Install the vibration damper.
- Install the intermediate pulley.
- Install eight new M16 x 76 mm vibration damper mounting bolts (P/N: 460 062 0071) into intermediate pulley and damper. Tighten all bolts following a criss-cross sequence. Torque to 200 N·m (148 lb·ft)
- Remove the flywheel guide pin from crankshaft.
- Install the plate (hub) using six bolts (P/N: 000000 001157), tightening in a criss-cross sequence. Torque bolts to 60 N·m (45 lb·ft).
- If previously removed, install lower bolts to the bottom of front fairing/bumper.
- Install all belts as needed.
Tools required
- Flywheel guide pin (J-46172) Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Vibration damper mounting bolts: 200 N·m (148 lb·ft)
- Plate (hub) mounting bolts: 60 N·m (45 lb·ft)
Source: Detroit Diesel service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.