Detroit Diesel — Install Blower Drive Support Assembly (4-53)
Installation
From a Detroit Diesel service manual — check it applies to your exact model before use.
Procedure
- Affix new blower drive support gasket to cylinder block rear end plate.
- Install support assembly by reversing removal.
- Tighten 3/8-24 support-to-end plate bolts with copper washers and 3/8-16 support-to-flywheel housing bolts to 35 lb-ft.
Specs & values
- 35 lb-ft
Source: Detroit Diesel service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.