Cummins — * Turbocharger - replacement.

For these Cummins models: GTA8.3, GTA8.3 CD1, GTAR 3.

Procedure

15.1 - 18.9 litres [4.0 - 5.0 U.S. Gal.] - 5.0 U.S. Gal.] > Se
1. Apply liquid soap around the regulator to check for
2. Check for leaks at all line connections by applying lig-
3. On CNGE turbocharged engine models, check the throt-
1. Fixed number of hours or calendar time, whichever
2. Utilization of a detailed oil analysis program.
1. Operate the engine until the water temperature reach-
2. Clean the area around the lubricating oil filter head.
3. Make sure that the correct oil filter is instalted. CNGE
4. Fill the oil filter with clean lubricating oil. The Jack of
5. Apply a light film of lubricating oil to the gasket seal-
6. Install the filter as specified by the filter manufacturer.
7. Check and clean the oil drain plug threads and seal-
8. Install the oil drain plug.
9. Fill the engine to the proper levels.
10. Operate the engine at idle to inspect for leaks at the
11. Stop the engine. Wait for approximately 5 minutes to
12. Add oil as necessary to bring the oil level to the at Fe
1. Turn the coolant shutoff valve to the “Off” position.
2. Remove and discard the coolant filter. Clean the gas-

Source: manual:CUMMINS GTA 8.3 Operation and Maintenance Manual 2001 (2).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.