Cummins/Onan — Page −5 Copyright 2017 Cummins Inc. Table of Contents (continued) TESTING THE ALTERNATOR 6−3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SECTION TITLE PAGE I
A Cummins/Onan service procedure — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Procedure
- 8. Wiring Diagrams
- 1. Introduction
- 3. A system schematic is provided in Section 8.
- 2. Control Operation
- 1. Turn the switch clockwise and allow it to pop
- 2. Move the Run/Off/Auto switch to Off.
- 3. Press the front panel Reset switch.
- 4. Select Run or Auto, as required.
Specs & torque values
- Copyright 2017 Cummins Inc.
- Copyright 2017 Cummins Inc.
- This symbol warns of immediate
- Flammable vapor can cause an engine to over-
- Copyright 2017 Cummins Inc.
- thorized Cummins distributor for more information.
- combustible and flammable liquid fuels and
- Do not store any flammable liquids, such as
- semi-tractor under the king pin. Jack stands for the
- Copyright 2017 Cummins Inc.
- Copyright 2017 Cummins Inc.
- Copyright 2017 Cummins Inc.
- formation regarding the PowerCommand Control
- Wheatstone Bridge or Digital Ohmmeter
- Copyright 2017 Cummins Inc.
- Cummins generator sets. It provides fuel control
- Copyright 2017 Cummins Inc.
- of the PowerCommand generator set control. All in-
- is set to the Standby mode. It is recommended that
- Copyright 2017 Cummins Inc.
- Copyright 2017 Cummins Inc.
- AC Ammeter: Indicates current output in percent of
- and ammeter. LEDs indicate the selected phase.
- Copyright 2017 Cummins Inc.
Source: manual:Cummins-DFHA-DFHB-DFHC-DFHD-spec-A-thru-J-service-manual-QST30-engine-with-PowerCommand-3.1-control.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.