Cummins/Onan — . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Generator Reassembly 6-22 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Aligning Generator

For these Cummins/Onan models: DFHA (Spec A−J), DFHB (Spec A−J), DFHC (Spec A−J), DFHD (Spec A−J).

Browse Cummins/Onan generators & specs →

Procedure

1. Introduction
3. A system schematic is provided in Section 9.
2. Control Operation

Specs & torque values

This symbol warns of immediate
Flammable vapor can cause an engine to overspeed and
genset where a flammable vapor environment can be
set safely. Contact your authorized Cummins Power
and flammable liquid fuels and gaseous fuels
Class
Do not store any flammable liquids, such as fuel,
pin. Jack stands for the front of the container are required
PowerCommand
Wheatstone Bridge or Digital Ohmmeter
of the PowerCommandgenerator set control. All in-
When the PowerCommand control is in the AUTO
Command control will initiate a starter cranking sig-
Command control will provide sufficient fuel to the
Command control checks the system bus voltage. If
If bus voltage is present, the PowerCommand con-
set to the Standby mode. It is recommended that
AC Ammeter: Indicates current output in percent of
and ammeter. LEDs indicate the selected p

Source: manual:900-0520 Onan DFHA DFHB DFHC DFHD (spec A-J) Genset Operators manual (10-2011).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.