Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Using the Recoil Starter

Cummins/Onan — Using the Recoil Starter

For these Cummins/Onan models: EGMBT (P4500), EGMBT/P4500, EGMBU (P5000e), EGMBU/P5000e.

Browse Cummins/Onan generators & specs →

Procedure

  1. 1. Open the fuel valve (see Figure 7).
  2. 2. Pull the choke rod out to close the choke if the engine is cold (see Figure 8).
  3. 3. Verify that the On/Off switch is in the ON position.
  4. 4. With one hand on the generator, grip the recoil handle with the other hand and pull it out quickly and smoothly. Repeat as necessary until the engine starts (see Figure 9).
  5. 5. As the engine warms up, gradually push the choke rod in.
  6. 6. Let the engine warm up for a few minutes before connecting tools or appliances. See Powering Tools and Appliances.

Source: manual:914-0116 Cummins EGMBT&U Operators Manual (8-2009) .pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.