Cummins/Onan TUG MT8-37 — Step 13 – Reinstall the fan
Installation · Fan / fan hub
For the Cummins/Onan TUG MT8-37, from the Cummins/Onan service manual.
Browse Cummins/Onan generators & specs →
Procedure
- Place fan on previously installed fan hub
- Apply red Loctite and thread in the (3) m8x1.25x20mm flange head bolts; hand tighten all bolts
- Using the torque wrench, tighten these bolts to 26 ft.lbs
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- M8x1.25x20mm flange head bolts: 26 ft.lbs
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.