Cummins/Onan TUG MT8-37 — Step 10 – Install fan support bracket on engine
Installation · Fan support bracket / standoff 132682
For the Cummins/Onan TUG MT8-37, from the Cummins/Onan service manual.
Browse Cummins/Onan generators & specs →
Procedure
- Slide bearing and assembled bracket over fan drive shaft
- Loosely install (2) m8x1.25x20mm flange head bolts to secure bracket to standoffs; do not tighten yet
- Install 132682 standoff using the m6x1.0x90mm hex head bolt and m6 flat washer
- Hand tighten the (2) m8 flange head bolts and the (1) m6 hex head bolt
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.