Cummins/Onan — Time ignition, plant stopped (JB battery ignition)
Adjustments
From a Cummins/Onan service manual covering: 10.0JC, 12.5JC, 15.0JC, 4.0JB, 5.0JB, 6.0JB, 6.1JB, 7.5JB, 7.6JB. Check it applies to your exact model before use.
Applies to: Cummins/Onan 10.0JC, Cummins/Onan 12.5JC, Cummins/Onan 15.0JC, Cummins/Onan 5.0JB, Cummins/Onan 6.0JB, Cummins/Onan 6.1JB, Cummins/Onan 7.5JB, Cummins/Onan 7.6JB, Cummins/Onan JB engine, Cummins/Onan JC engine
Procedure
- Disconnect ignition points lead, install continuity lamp and battery
- Rotate flywheel clockwise until TC mark nears timing pointer
- Rotate slowly until light goes out at 5 deg ATC
- If incorrect, align 5 deg ATC mark and loosen breaker plate
- Rotate plate until light goes out, tighten and check
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Ignition at 5 deg ATC stopped; 25 deg BTC running
Full service-parts list: Cummins/Onan 10.0JC →, Cummins/Onan 12.5JC →, Cummins/Onan 15.0JC →, Cummins/Onan 5.0JB →, Cummins/Onan 6.0JB →, Cummins/Onan 6.1JB →, Cummins/Onan 7.5JB →, Cummins/Onan 7.6JB →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.