Cummins/Onan RSS100 / RSS200 — Installation - AC Connections
Installation · Power terminals
For the Cummins/Onan RSS100 / RSS200, from the Cummins/Onan service manual.
Browse Cummins/Onan generators & specs →
Before you start
- Failure to prevent the generator set from starting before wiring procedures presents a shock hazard.
- Make sure that both AC power sources are disconnected.
Procedure
- Test the operation of the generator set from its own control.
- Stop the generator set and remove the negative lead from the cranking battery to prevent starting.
- Make sure that both AC power sources are disconnected.
- Connect power cables of sufficient size to the line, load, and generator terminals or circuit breakers marked A and B.
- Tighten the terminal lugs as indicated in Table 2 or Table 3.
Tools required
- Wire brush Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Torque per Table 2 or Table 3
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.