Cummins/Onan — − Routine maintenance (not repair) of shop equipment

For these Cummins/Onan models: Genset, Marine (Above Deck), Genset, Marine (Below Deck).

Browse Cummins/Onan generators & specs →

Procedure

1. Engine or generator sets mounted in equipment where 90 percent of the work can be
2. Engine or generator set can be accessed without removing any doors or panels.
3. Interfering application hardware can all be removed.
4. Clearance is sufficient for hands, wrenches, and drain and fill operations, making
5. Engine or generator set mounted in equipment where 70 percent of the work can be
6. Access to the engine can be gained by removing access panels or doors.
7. On 80 percent of the operations, interfering application hardware can be removed.
8. On 80 percent of the operations, clearance is sufficient for hands, wrenches, service
9. Engine or generator set mounted in equipment where 50 percent of the work can be
10. Access to the engine or generator set can be gained by removing the hood, structural
11. On 60 percent of the operations, interfering application hardware can be removed.
12. On 60 percent of the operations, clearance is sufficient for hands, wrenches,
13. Engine or generator set mounted in equipment where 25 percent of the work can be
14. Access to the engine or generator set is limited due to interference from permanently
15. On 40 percent of the operations, clearance is sufficient for hands, wrenches, service
16. Determine the actual work performed:
17. Determine the Accessibility Code:
18. Determine applicable SRCT:
19. Determine the appropriate repair SRT:
20. Determine the appropriate troubleshooting SRT:

Source: manual:900-0614 Onan MDKUB MDKWB Repair Times.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.