Cummins/Onan — Remote Control Panel and Connector Wiring
Installation
From a Cummins/Onan service manual — check it applies to your exact model before use.
Applies to: Cummins/Onan MDKAV, Cummins/Onan MDKAW, Cummins/Onan MDKAZ, Cummins/Onan MDKB, Kubota D1105 engine, Kubota V1305 engine, Kubota V1505 engine, Kubota V1903B engine, Kubota V2203B engine, Kubota V2803B engine
Procedure
- Remove the access cover and the rubber plug in the grommet slot.
- Pull the connector out, fit the grommet into the slot and secure the access cover (4 screws).
- Join the connector with its mate from the remote control panel.
- Use 16 AWG wires and sealed 8-pin Deutsch connectors for the wiring harness.
- Use 14 AWG wires for connector pins 2, 3 and 4 if harness length is 45 to 150 feet (14 to 46 meters).
Specs & values
- Both Start/Stop switch positions must be momentary-contact type
- 8-pin FridayParts $14.64 Deutsch connector
Full service-parts list: Cummins/Onan MDKAV →, Cummins/Onan MDKAW →, Cummins/Onan MDKAZ →, Cummins/Onan MDKB →, Kubota D1105 engine →, Kubota V1305 engine →, Kubota V1903B engine →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.