Cummins/Onan — Remote Control Assembly Installation (Begin Spec R)
Installation
From a Cummins/Onan operator's manual covering: 4.0CCK, 4.0CCK-3CR, 5.0 CCK, 5.0CCK, 5.0CCK-3CR, 5.0CCK-3R. Check it applies to your exact model before use.
Applies to: Cummins/Onan 4.0CCK, Cummins/Onan CCK engine
Before you start
- To prevent noxious gases from entering the interior of the motor home, seal any openings made in the plant compartment for the lead wires.
Procedure
- Measure and cut correct size hole in wall for mounting switch assembly.
- Open the electric plant compartment and connect #18 wire to the printed circuit board on the generator.
- Thread leads through plant compartment to inside of motor home.
- Run lead ends from inside motor home through the wall cutout.
- Connect leads to remote control terminals (terminal numbers stamped on back of remote control switch).
- Insert remote control switch into wall cutout and secure with #5 wood screws.
- Seal any openings made in the plant compartment for the lead wires.
Specs & values
- Switch #300-942 opening 1-5/16 in wide by 1-5/8 in high
- Deluxe switch #300-943 opening 4-1/8 in wide by 2-3/8 in high
Full service-parts list: Cummins/Onan 4.0CCK →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.