Cummins/Onan P1700i — Recoil starter assembly
Maintenance
For the Cummins/Onan P1700i, from the Cummins/Onan service manual.
Applies to: Cummins/Onan P1700i, Cummins/Onan EH09-2D engine
Before you start
- Wear protective goggles before starting assembly.
- Be sure the retaining ring is fitted into the grooves.
Procedure
- Install the ratchet and fasten it with retaining ring E.
- Install the spiral spring in the reel.
- Apply grease to the case.
- Properly orient the inner end of the spring.
- Hold the reel and softly drop it into the case from the top.
- Move the reel gently counter-clockwise, making sure the spring catches.
- Install the ratchet guide and return spring into the reel.
- Install the friction spring, friction plate and retaining ring C.
- Thread the rope through the reel and tie the end.
- Wind the rope clockwise seven times with the rope hanging from the reel.
Tools required
- Protective goggles Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.