Cummins/Onan — Nikki Carburetor Idle Mixture Screw Adjustment
Adjustments
From a Cummins/Onan service manual — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Before you start
- Take care not to change setting
Procedure
- Carefully remove screw adjustment limiter cap.
- Turn idle mixture screw inward until lightly seated.
- Back out exactly one (1) full turn.
- Replace limiter cap with limiter lever at LOW altitude position.
- Confirm limiter cap is fully seated over screw head.
Tools required
- Screwdriver Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Idle mixture screw: 1 full turn out
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.