Cummins/Onan — Linkage Adjustments (Type C)
Adjustments · electric governor linkage (Type C)
From a Cummins/Onan service manual — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Procedure
- With the set not operating, check there is approximately a 1/16 inch gap between the low idle speed stop and the governor control lever.
- Loosen both lock nuts and turn the threaded rod.
- Tighten the lock nuts after the proper gap is obtained.
Tools required
- wrenches Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 1/16 inch gap
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.