Cummins/Onan — Linkage Adjustments (Beginning Spec F)
Adjustments · Electric governor linkage
From a Cummins/Onan service manual — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Procedure
- Assemble the governor linkage as shown in Figure 2; thread each female component three to four turns onto each male component and set the lock nuts.
- Thread the assembled governor linkage three or four turns onto the actuator shaft.
- Snap the ball joint of the governor linkage onto the ball stud of the throttle lever.
- Loosen the throttle lever screw.
- Rotate the throttle linkage to the full speed stop and extend the actuator shaft to its end of travel.
- Tighten the throttle lever screw.
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.