Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Installation Procedure

Cummins/Onan — Installation Procedure

For these Cummins/Onan models: EGMBT (P4500), EGMBT/P4500, EGMBU (P5000e), EGMBU/P5000e.

Browse Cummins/Onan generators & specs →

Procedure

  1. 1. Install the handle assembly (handle, bracket, hinge pin, grips, end plugs, two cotter pins, and fasteners).
  2. 2. Block up the generator set under both frame tubes as shown below. Place a block under the center of the cross-member on the exhaust end.
  3. 3. Install the leg assembly.
  4. 4. Install the wheel and axle assembly (axle assembly and wheel assemblies).

Source: manual:914-0116 Cummins EGMBT&U Operators Manual (8-2009) .pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.