Cummins/Onan — Initial Start-Up/Inspection
Operation · generator set
From a Cummins/Onan service manual — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Before you start
- Fuel presents hazard of explosion or fire. If fuel leaks are found, shut down immediately.
- Exhaust gas presents hazard of severe personal injury or death. Do not operate if excessively noisy.
Procedure
- Place Start/Stop switch to START position. Engine should crank and start.
- After generator set starts, check for fuel leaks. If found, shut down immediately, turn off fuel supply, and repair leaks.
- Examine exhaust system for leaks. If found, shut down immediately and repair.
- Refer to Operator's Manual and perform Break-in Procedure.
- Stop generator set by placing Start/Stop switch to STOP position.
- Start at remote control: place Remote Start/Stop switch to START position.
- After start, check battery condition meter (if equipped) to confirm proper operation.
- Allow generator set to operate at normal load and monitor fuel supply connections, exhaust system, unit performance, and noise reduction.
- If performance is not correct, refer to Service Manual for adjustment or contact an Onan distributor.
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.