Cummins/Onan — Generator Stator and Rotor Assembly Torquing

For these Cummins/Onan models: 5.5HDKBA-2732A, F000 123456.

Applies to: Cummins Onan 5 5Hdkba 2732A, Cummins Onan F000 123456

Procedure

1. Install stator and end bell.
2. Torque nuts on through-studs to 19-21 ft-lbs (26-28 N•m).
3. Make certain the B1 lead is placed through the grommet in the baffle ring and out the air discharge opening in the adapter.
4. Torque the rotor-through-stud nut to 55-60 ft-lbs (75-81 N•m).
5. Torque the stator through bolts and end bell bracket bolts to 8 lb-ft (11 N•m).
6. Torque the fan hub bolt to 45 lb-ft (61 N•m).
7. To keep the rotor from turning while tightening the fan bolt, hold the pulley bolt with a wrench.

Source: manual:981-0535 Onan HDKB (spec A-F) Diesel RV Genset Service manual (01-2010).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.