Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›G-VIBRATION ISOLATOR

Cummins/Onan — G-VIBRATION ISOLATOR

For these Cummins/Onan models: 4.0CCK, 4.0CCK+IR/, 4.0CCK-3CR/, 4.0CCK-3R/, 5.0CCK.

Applies to: Cummins Onan 4 0Cck

Before you start

  • of fuel siphoning out of the tank if the line should break. Install lines so they are accessible at all times and protected from mechanical injury. Use nonferrous metal straps, without sharp edges, to secure the fuel lines. EXHAUST SYSTEM Observe the following when installing the set’s exhaust system: 1. Construct exhaust system to prevent damage from leakage and vibration. Use automotive type hangers and connections under the vehicle.
  • | Do not install the exhaust outlet

Procedure

  1. Construct exhaust system to prevent damage from
  2. Use an insulating thimble where exhaust piping
  3. Terminate the exhaust outlet to the rear of the set

Tools required

  • automotive type hangers

Source: manual:927-0310 Onan CCK (spec A-R) Genset Operators & Parts manual (03-1971).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.