Cummins/Onan FM-JFE2 — Starting Plant - Electric Start
Operation · engine
For the Cummins/Onan FM-JFE2, from the Cummins/Onan service manual.
Browse Cummins/Onan generators & specs →
Before you start
- Proper ventilation provided
- Plant properly installed
Procedure
- See that lubricating oil, fuel and cooling liquid have been added.
- Open the disconnect switch.
- Press the start button and hold down for about five seconds; then release.
- Repeat after about 10 seconds until the plant starts.
- If plant does not start, check fuel and ignition systems and repeat.
- After engine is warm, close the electrical disconnect switch.
- For first 10 hours run at only 1/2 load.
Specs & values
- Rated speed 1800 RPM
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.