Cummins/Onan — Exerciser Clock Programming

Operation

From a Cummins/Onan service manual — check it applies to your exact model before use.

Browse Cummins/Onan generators & specs →

Procedure

1. Press the R button to reset all memory (installation and setup only).
2. Press the clock button.
3. Press the h button to set the hour of the day (24-hour time).
4. Press the m button to set the minutes of the hour.
5. Press the 1-7 button to advance the indicator bar over the desired day number (1 = Sunday).
6. Press the Pr button to enter the time.
7. Press the I/O button; an 'I' appears in the upper display window for start time.
8. Press h, m and 1-7/Q buttons to set the start hour, minute and days.
9. Press the I/O button; an '0' appears for stop time.
10. Press h, m and 1-7/Q buttons to set the stop hour, minute and days.
11. Press the Pr button to enter the complete start/stop program.
12. Repeat the procedures to enter more programs; a maximum of ten programs can be entered.

Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Cummins/Onan repair guides →