Cummins/Onan — Enclosure Mounting
Installation
From a Cummins/Onan service manual — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Before you start
- Make sure no wires, plumbing or gas lines run behind the mounting area before drilling the mounting holes.
Procedure
- Remove the front panel assembly from the enclosure.
- Punch out necessary hole(s) in the enclosure for conduit or wires.
- Locate the desired location on wall. Using the enclosure as a template, mark the required holes.
- Attach mounting brackets to annunciator using the screws provided.
- Mount the enclosure securely to the wall at the desired location.
- Install conduit and wiring as needed.
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.