Cummins/Onan — Configuring Annunciator Lamps
Adjustments · Status Lamps
From a Cummins/Onan service manual — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Procedure
- Select Control button from left toolbar.
- Select Data (F9) from the bottom toolbar.
- Set the input nviMfgTest = 6 to turn all lamps on in their configured state.
- Under Inputs, scroll to nciLampConfig and select Modify (F2).
- Select lamp field and select Modify (F2).
- Enter the lamp number to configure lamps 1 ... 20 and press Done (F10).
- In the same manner, modify the color, horn, and flash fields as desired.
- Select Done (F10) to activate changes.
- After configuration, reset the node to resume normal operation.
Specs & values
- lamp: 1 ... 20
- color: GREEN, RED, AMBER
- horn: OFF, ON
- flash: OFF, ON (flashes lamp when activated, 1 Hz)
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.