Cummins/Onan CK-216E — Bearing Installation
Repair & overhaul · Bearings
For the Cummins/Onan CK-216E, from the Cummins/Onan service manual.
Browse Cummins/Onan generators & specs →
Procedure
- Install crankshaft bearings from inside cylinder block with oil holes aligned.
- Press or drive both bearings until flange is flush with inner end of boss.
- Install camshaft bearings from outside; front bearing flush with boss, rear bearing flush with welch plug groove.
- Line bore or line ream camshaft bearings after installation to 0.0015 to 0.003 inch clearance.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Camshaft bearing clearance 0.0015 to 0.003 inch
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.