Cummins/Onan — Camshaft Cover - Installation
Installation
From a Cummins/Onan service manual — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Procedure
- Install new gaskets.
- Position camshaft cover and install bolts in sequence shown.
- Tighten to 10 Nm (89 lb-in).
- Reconnect crankcase ventilation tube.
- Install CMP sensor and bolt, tighten to 7 Nm (62 lb-in).
- Reconnect CMP sensor, ignition coil and CHT sensor connectors.
Specs & values
- Camshaft cover bolts 10 Nm (89 lb-in)
- CMP sensor bolt 7 Nm (62 lb-in)
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.