Cummins/Onan — Binding (Self-Installation)
Installation · Annunciator
From a Cummins/Onan service manual — check it applies to your exact model before use.
Browse Cummins/Onan generators & specs →
Procedure
- Make sure the Annunciator, Genset and/or ATS LONWORKS modules are all powered and all are connected to the twisted-pair data bus.
- Make sure S2-5 and S2-6 are configured for the desired Annunciation.
- Install the front panel assembly into enclosure or panel.
- The front panel Network Status lamp should be on (amber) indicating it is powered but not bound.
- Press and hold the Silence/Lamp Test button until the Network Status lamp begins flashing (amber).
- Release the Silence/Lamp Test button.
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.