Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›BATTERY INSTALLATION

Cummins/Onan — BATTERY INSTALLATION

For these Cummins/Onan models: EGMBT (P4500), EGMBT/P4500, EGMBU (P5000e), EGMBU/P5000e.

Browse Cummins/Onan generators & specs →

Procedure

  1. 2. Introduction
  2. 2.7
  3. 1. Install the handle assembly (handle, bracket, hinge pin, grips, end plugs, two cotter pins,
  4. 2. Block up the generator set under both frame tubes as shown below. Place a block under
  5. 3. Install the leg assembly.
  6. 4. Install the wheel and axle assembly (axle assembly and wheel assemblies).

Source: manual:914-0116 Cummins EGMBT&U Operators Manual (8-2009) .pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.