Cummins/Onan — Adjust governor speed and sensitivity
Adjustments
From a Cummins/Onan service manual covering: 10.0JC, 12.5JC, 15.0JC, 4.0JB, 5.0JB, 6.0JB, 6.1JB, 7.5JB, 7.6JB. Check it applies to your exact model before use.
Applies to: Cummins/Onan 10.0JC, Cummins/Onan 12.5JC, Cummins/Onan 15.0JC, Cummins/Onan 5.0JB, Cummins/Onan 6.0JB, Cummins/Onan 6.1JB, Cummins/Onan 7.5JB, Cummins/Onan 7.6JB, Cummins/Onan JB engine, Cummins/Onan JC engine
Before you start
- Oversensitive adjustment may cause hunting
Procedure
- Hold governor spring stud, turn nut to set speed
- Use a reed type frequency meter on generator AC output
- Prior Spec R: turn spring stud counterclockwise for more sensitivity
- Adjust for maximum sensitivity without hunting
- Begin Spec R: turn speed nut clockwise to increase speed
- Begin Spec R: turn ratchet nut counterclockwise to increase spring tension
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Maximum 3 cps spread no load to full load
Full service-parts list: Cummins/Onan 10.0JC →, Cummins/Onan 12.5JC →, Cummins/Onan 15.0JC →, Cummins/Onan 5.0JB →, Cummins/Onan 6.0JB →, Cummins/Onan 6.1JB →, Cummins/Onan 7.5JB →, Cummins/Onan 7.6JB →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.