Cummins/Onan 5.6TGHAA11381C — Manual Stopping
Operation · genset
For the Cummins/Onan 5.6TGHAA11381C, from the Cummins/Onan operator's manual.
Applies to: Cummins/Onan TGHAA
Before you start
- Failure to push control switch to AUTO before leaving site will render genset unavailable for automatic standby service.
Procedure
- Push control switch to Off.
- Allow engine to cool down with loads disconnected.
- Push control switch to Auto before leaving site if automatic standby service is desired.
Full service-parts list: Cummins/Onan TGHAA →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.