Cummins/Onan 305CCK / 5CCK — Installing Readi-Pull Starter, Units Beginning Spec D
Installation
For the Cummins/Onan 305CCK / 5CCK, from the Cummins/Onan operator's manual.
Applies to: Cummins/Onan 5CCK
Before you start
- Recoil spring may unwind and cause injury if let fly wildly.
Procedure
- Install new ratchet wheel against rope sheave with lock washer and flywheel mounting screw.
- Install special mounting nuts in blower housing if needed; reinstall housing.
- Install centering pin in starter center screw allowing 3/8 inch to protrude.
- Center starter assembly over ratchet wheel with centering pin engaging center hole of flywheel mounting screw.
- Mount starter with hex head screw, lock washer, and two flat washers at each mounting arm.
- Adjust direction of rope pull by loosening four clamp screws; tighten securely.
Specs & values
- Centering pin protrudes 3/8 inch.
Full service-parts list: Cummins/Onan 5CCK →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.