Cummins/Onan — 10 WF-2073 (2)
For these Cummins/Onan models: G&855, G12 GTAi2 Ga55 GTA855-A GTA855-B GTAI9 GTA28.
Browse Cummins/Onan generators & specs →
Before you start
- s:
- If replacement capscrews are of a higher grade than originally supplied, adhere to torque specifications for
- If there is no fitting, then the tubing
- should be taken to assure that
- [f there is no fitting, the tubing
- should be taken to assure that
- s:
- The following list contains addresses and
Procedure
- Always use the torque values listed above when specific torque values are not avaiable.
- Donor use above values in place of these specified in other sections of this manual: special attention should be observed
- Read and Follow the manufacturer’s manu-
- Test the condition of the batteries before
- Check the condition of the filter material on
- Remove the cell saver cap, check the Oxygen
- Connect the temperature reducing tubing to
- After each 5 minutes of sampling, purge
- the unit with clean ambient air until the read-
- 2.
- Read and Follow the Teledyne manuals for
- 7.
- Remember that the water trap will need to
- The back pressure in the exhaust system
- After each 5 minutes of sampling, purge the
- When not in use, the unit should be turned
- Allow a minimum of 30 seconds for the gas
- Adjust the power valve on the carburetor.
- After each adjustment of the power valve it
- If a problem originates with a salesperson or
- If a problem originates with a sales or service
- If a problem originates with a CNGE autho-
- lf a problem originates with a distributor,
Tools required
- rque Torque Torque
- [N«m] FtLbs [Nem] Ft-Lbs [Nem] Ft-Lbs [N+m]
- Gauge
- Wrench
- Gauge
- Gauge
- Gauge
Specs & torque values
- --------++-~---- 8-(3-4 Thermostats & Seals ---------+-------4- 6-6
- --------------- 8-4 Photo #3-25 3-9
- Tool
- Description
Source: manual:Cummins Gas GTA12-19-28-855 Manual 2001.pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.