Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Procedure 17

Cummins — Procedure 17

For these Cummins models: GTA38, GTA38, GTA50, GTA50.

Browse Cummins generators & specs →

Procedure

  1. 3. Install intake air pipe from the air adapter to the
  2. Aftercooler asembly and install all hose clamps.
  3. 4, Reconnect electrical pulg to actuator.
  4. 5. Reconnect battery power to engine.
  5. Governor Controller - Remove and Replace
  6. 4. Refer to the Woodward Flo-Tech Speed Control
  7. Manual 04173A. This manual was included with
  8. your literature pack for this engine.
  9. Governor Adjustment
  10. Adjustment Procedure
  11. 1. Reler to the Woodward Flo-Tech Speed Control

Tools required

  • 3. Install intake air pipe from the air adapter to the

Source: manual:Cummins Gas GTA38-50 Manual 1999 (2).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.