Cummins — Remove the hose.

For these Cummins models: GTA38, GTA38, GTA50, GTA50.

Browse Cummins generators & specs →

Procedure

1. 7. Loosen the clamps.
2. 8. Remove the four cap-screws and nuts.
3. Caution: The component weighs 23 kg [50 Ib] or
4. more. To avoid personal injury, use a hoist or get
5. assistance to lift the component.
6. 9. Remove the turbocharger and gasket.
7. 10. Discard the gasket.
8. 11.On newer engines, remove the hose and clamps.
9. Discard the hose. Check the condition of the
10. clamps. Discard the clamps if they are cracked or
11. have damaged threads.
12. Install Turbocharger:
13. Caution: Check to be sure the correct turbocharger
14. assembly number can be found on the data tag that is
15. mounted on the turbocharger. Many turbochargers
16. appear the same physically but contain different internal
17. parts. If the wrong turbocharger assembly is used,
18. engine performance will be less than specification or the
19. engine will be damaged due to excessive cylinder pres-
20. sure and temperature.
21. Note: The turbochargers, mounting hardware and con-
22. nections are not the same for ail models of K38 or K50
23. engines. CNGE use turbochargers specifically matched
24. for the spark-ignited engines. CNGE also only use one
25. configuration for the GTA38 and GTASO engine series.

Source: manual:Cummins Gas GTA38-50 Manual 1999 (2).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.