Craftsman Marine — Replacing the oil filter
Maintenance · Lubrication system
From a Craftsman Marine service manual — check it applies to your exact model before use.
Browse Craftsman Marine generators & specs →
Before you start
- Be careful not to twist the O-ring.
Procedure
- Remove the oil filter with a filter wrench.
- Clean the filter mounting surface; coat the O-ring with engine oil and install the new filter, tightening by hand.
- Run the engine for several minutes and make sure no oil leaks.
- Stop the engine and check the oil level; add oil if necessary.
Tools required
- Filter wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil filter tightening torque: 10.8 to 12.7 N·m (1.1 to 1.3 kgf·m) [7.96 to 9.40 lbf·ft]
Source: Craftsman Marine service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.