Clarke — How to clean the screen strainer of the fuel lift pump
Maintenance · Fuel lift pump strainer
From a Clarke operator's manual — check it applies to your exact model before use.
Applies to: Perkins 1000 Series engine
Before you start
- The turbocharger heat shield must be replaced when finished.
Procedure
- Remove the cover and seal from the top of the lift pump. On 6T and 6TW engines remove the small turbocharger heat shield above the pump.
- Remove the screen strainer.
- Carefully wash the screen and lift pump body.
- Reinstall the screen, being careful to align the hole.
- Install the cover and seal, making sure it is seated properly. Do not over tighten the cover screw. Reinstall the heat shield on 6T and 6TW engines.
- Operate the hand priming pump to aid in purging air from the system.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Perkins 1000 Series engine →
Source: Clarke operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.