Clarke — Changing the lubricating oil filter

Maintenance · Lube oil filter

From a Clarke operator's manual — check it applies to your exact model before use.

Applies to: Perkins 1000 Series engine

Procedure

1. Turn the engine off using the proper shutdown procedure.
2. Put a tray under the filter to retain spilt lubricating oil.
3. Remove the filter with a strap wrench or similar tool. Ensure the adaptor is secure in the filter head.
4. Clean the filter head.
5. Add clean engine lubricating oil to the new filter and allow it to pass through the element.
6. Lubricate the top of the filter seal with clean engine lubricating oil.
7. Fit the new filter and tighten it by hand only. Do not use a strap wrench.
8. Ensure there is oil in the sump; on turbocharged engines ensure the engine will not start and operate the starter until oil pressure is obtained.
9. Operate the engine and check for leakage; check oil level when cooled and top up if necessary.

Full service-parts list: Perkins 1000 Series engine →

Source: Clarke operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Clarke repair guides →