Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Chrysler›Starting and Stopping the Engine

Chrysler — Starting and Stopping the Engine

Operation

From a Chrysler operator's manual covering: IND. 30, IND. 31, IND. 32, IND. 33, IND. 908A, IND. 931. Check it applies to your exact model before use.

Before you start

  • Do not hold starting motor switch in for periods longer than 15 seconds.

Procedure

  1. Open throttle at 1/4 opening.
  2. Ensure clutch, gear shift lever or power take-off lever is in neutral.
  3. Turn on ignition switch and press starting motor switch until engine starts.
  4. Do not hold starting motor switch longer than 15 seconds.
  5. Watch oil pressure gauge; if no pressure after about 10 seconds, stop engine and investigate.
  6. To stop: close throttle and disengage clutch.
  7. Allow engine to run at idle speed for a few minutes.
  8. With throttle closed, turn off ignition.

Specs & values

  • Oil pressure should register within about 10 seconds

Source: Chrysler operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Chrysler repair guides →