Chrysler — Preparation for Storage
Maintenance · engine
From a Chrysler operator's manual covering: IND. 52, IND. 53, IND. 54, IND. 56. Check it applies to your exact model before use.
Procedure
- Drain lubricating oil from engine and add 2-1/2 quarts Rust Preventive Oil.
- Drain cooling system, add MOPAR Rust Resistor and fill with clean water.
- Run engine at idle speed for three or four minutes avoiding overheating.
- Remove top of carburetor air cleaner and pour 3/4 pint Rust Preventive Oil through carburetor air intake at approximately 1000 rpm.
- Turn off ignition as soon as oil has been drawn into combustion chamber.
- Drain Rust Preventive Oil from crankcase.
- Remove spark plugs and pour one ounce of Rust Preventive Oil into each spark plug opening.
- Turn engine over four or five revolutions with starting motor and install plugs.
- Drain cooling system.
- Drain fuel system tank, fuel pump and filter and carburetor.
- Operate carburetor throttle lever several times to empty accelerator pump system.
- Remove carburetor air cleaner, oil filler cap air cleaner and outlet ventilator pipe air cleaner; seal openings.
- Replace oil filter element after cleaning filter housing.
- Remove storage battery and store in cool, dry place.
- Protect engine with waterproof cover if exposed to weather.
Source: Chrysler operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.